The reasons of film folding:
1. The thickness of film is not even
2. Cooling effect is poorly, bubble not Very Stable and flickered,easy to produce folding
3. The blow-up ratio is too large, the bubble is not Very stable,rock back and forth,so it’s easy to produce folding
4. Angle of collapsing frame is too large, membrane bubble get squashed in short distance, so the film folding;
5. The pressure on both sides of the traction roller is uneven, one higher than the other;
6. Between the guide roller's axis is not parallel, influence the stability and peace malleable of the film , so appear buckling.
Solutions
1.Adjust the thickness of the film, to keep thickness is even;
2. To improve the effect of cooling, so the film can be fully cooled;
3.Decrease the blow-up ratio;
4.Appropriate reduce the angle of collapsing frame.
5.Adjust the traction roller pressure, to ensure the film force is uniform;
6.Check the axis of guide shaft, and parallel to each other.
山东鼎信塑料机械有限公司
联系人:张经理
手 机:13863413850 / 18963088341
电 话:0531-76257333
传 真:0531-76258366
地 址:山东省莱芜高新区山财大街56号
山东鼎信塑料机械有限公司
联系人:张经理
手 机:13863413850 / 18963088341
电 话:0531-76257333 传 真:0531-76258366
地 址:山东省莱芜高新区山财大街56号